51
TN4FCXA2
j
-EDF-
E
Menu D: Self-diagnosis (SELF CHECK)
The configuration menu “D:SELF CHECK”
displays the alarm and error messages.
In the selection menu “1:AMP TEMP”
(AMPLIFIER TEMPERATURE), the
temperature is displayed.
In case of overrun of the temperature limits,
“TEMP ALM” (TEMPERATURE ALARM)
appears on the third line of the display.
The selection menu “2:ALM CHECK” (ALARM
CHECK) (error signal) indicates a possible
error.
The display “ALM-CHECK GOOD” means that
there is no defect.
In case of problems, the following displays
are possible:
- CELL FLT (C ), error in the measuring cell
- EEPROM (AMP) FLT, EEPROM defective
in the amplifier
- EEPROM (CELL) FLT, EEPROM
defective in the measuring cell
- TEMP.ALM, temperature alarm
- XMTR FAULT, electronic module faulty
Menu C: Display of the measurement
value (data)
The measurement values are displayed in the
configuration menu “C:DATA”.
The flashing “*” indicates that the transmission
of the measurement values to the mobile
communicator by the transmitter is in progress.
The display “%” is increased or reduced by a
figure behind the decimal point by pressing
<CHNG>.
In this menu, the mobile communicator
switches automatically into stand-by mode if
no key is pressed for more than 10 minutes.
Then just pressing the <CL> makes the
measurement values reappear on the display.
C-1: DATA
STANDBY
PUSH CL KEY
XXX. X %FLOW
C: DATA
< INC > < ENT >
XXXXX kPa
< CHANGE > < CL >
CL
CL
D-1: SELF CHECK
D-2: SELF CHECK
ALM CHECK
< 1 > AMP TEMP
D:
SELF CHECK
< INC > < ENT >
< 2 > ALM CHECK
< 1 > < 2 > <CL >
< CL >
GOOD
D-2: SELF CHECK
TEMP=XXX.X °C
(YYY.Y °F)
< CL > <INC>
D-2: SELF CHECK
CELL FAULT (C1)
< CL > < INC >
D-2: SELF CHECK
TEMP=XXX.X °C
TEMP.ALARM
Temperature is displayed in C and F
alternately at each press of the <INC> key.
1
CL
1
2
2
CL
CL
3
4
5
6
C-1: DATA
XXX. XX %FLOW
XXXXX kPa
< CHANGE > < CL >
CL
:
"FLOW" is displayed
when output mode is
square root extraction
mode.
:
" " flickers is displayed
when the communica-
tion between transmitter
and HHC is normal.
(HHC is not used for 10 minutes)
CHNG
INC
CHNG
ENT
INC
ENT
(Temperature alarm is displayed)
INC
CL
(Trouble in transmitter)
E: PRINT
B:
OUTPUT ADJ
