Fuji Electric FCX-AII-V4 Series, User Manual And Service Instructions

Page: 40 / 76

40
TN4FCXA2
j
-EDF- E
6.1.2 Starting up the FXW communicator
• Put the switch of the mobile communicator in the (ON) position.
Without its key, or with communicator in the OFF position (off / vertical), the transmitter settings can
only be displayed.
To change the settings for the transmitter, the key to the FXW communicator must be in horizontal
position. If this is not the case, the lower line of the screen of the FXW will indicate “ INHIBIT KEY OK? ”
to indicate that the key must be in the ON position allowing the writing of new settings in the transmitter.
NB
:
“
INHIBIT KEY
” means that the key authorises or inhibits (prohibited) the writing of settings in the transmitter.
• The name of the device and the version of its software are displayed on the screen.
After approximately 4 seconds, the statement “ PUSH MENU KEY ” appears (press the menu key).
With the printer connected, “ PAPER FEED? ” is displayed in an intermediate step on the display. The
feeding of the printer paper can be triggered by pressing the <INC> button.
“ PUSH MENU KEY ” appears on the display when the clear key < CL > is pressed.
The screen displays “ RECEIVING START ” (receipt of data from the transmitter). When the reception
of the data is complete, the device automatically switches to the configuration menu 1 which contains
the label of the device (TAG).
In the event of a fault, “NO CONNECTION” appears on the display. The display returns to “PUSH
MENU KEY” after the < CL > key is pressed.
The causes can be the following:
- The 4-20mA loop is not supplied with power.
- Cut off of the 4-20mA loop.
- The load resistance is less than 250 Ω.
- The mobile communicator is incorrectly connected.
Configuration menus of the FXW mobile communicator
The use of the communicator is done by means of a menu. The identifications of the keys that are active
for the next step appear in parentheses ( < > ) on the lower line of the display.
The configuration menus can be selected by pressing the keys
INC
(Increment: configuration “n+1”) or
DEC (dedrease: configuration “N -1”), and the highest ones may be selected directly by the corresponding
keys.
The key < CHNG > ( CH A NG E) in the corresponding configuration menu makes it possible to modify the
characteristics and enter the new data using the alphanumeric keyboard. To enter letters, the < ALHA >
(the
Al
P
HA
key) must first be pressed each time before a letter is entered.
Spaces are added with spacebar <ALHA>, < >. Data entered by mistake can be cleared by pressing
<CL> ( CL EAR).
The modification, once introduced in the FXW, must be transmitted to the transmitter by pressing the
<ENT> (EN
T
ER, input).
As a safety measure, the FXW makes the following request once again: “ CHNG OK? ” ( CH A NG E OK ?,
exact change?), and the modification must be validated by pressing on the < ENT > key once again.
From this moment only, the modified data are written in the transmitter and “ WRITE ” appears on the
display.
The minimum version of the FXW must be 7.1 for it to be able to communicate with
the transmitter.
If an earlier version is being used, please contact Fuiji Electric France for an update.
Important