Freescale Semiconductor MPC5553, Reference Manual

Page: 583 / 1208

MPC5553/MPC5554 Microcontroller Reference Manual, Rev. 5
14-22 Freescale Semiconductor
14.3.4.2.10 Transmit Control Register (TCR)
The TCR is read/write and is written by the user to configure the transmit block. This register is cleared at
system reset. Bits 29 and 30 should be modified only when ECR[ETHER_EN] = 0.
30 DRT Disable receive on transmit.
0 Receive path operates independently of transmit (use for full-duplex or to
monitor transmit activity in half-duplex mode).
1 Disable reception of frames while transmitting (normally used for
half-duplex mode).
31 LOOP Internal loopback. If set, transmitted frames are looped back internal to the
device and the transmit output signals are not asserted. The system clock is
substituted for the FEC_CLK when LOOP is asserted. DRT must be set to
zero when asserting LOOP.
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
R 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
W
Reset 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
Address Base + 0x00C4
16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31
R 0 0 0 0 0 0 0 0 0 0 0 RFC_
PAUSE
TFC_
PAUSE
FDEN HBC GTS
W
Reset 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
Address Base + 0x00C4
Figure 14-12. Transmit Control Register (TCR)
Table 14-15. TCR Field Descriptions
Bits Name Description
0–26 — Reserved, should be cleared.
27 RFC_PAUSE Receive frame control pause. This read-only status bit will be asserted when a
full-duplex flow control pause frame has been received and the transmitter is paused
for the duration defined in this pause frame. This bit will automatically clear when the
pause duration is complete.
Table 14-14. RCR Field Descriptions (Continued)
Bits Name Description