Foma P905i, Manual

Page: 103 / 140

101
So
un
d/
Scre
en/
Li
gh
t S
e
ttin
g
s
1
m
Settings Sound Keypad sound
ON or OFF
The confirmation tone sounds twice when charging
starts/ends.
1
m
Settings Other settings Battery
Charge sound ON or OFF
When a call is liable to be disconnected midway
because of bad radio wave conditions, an alarm sounds
to inform you right before possible disconnection.
1
m
Settings Talk Quality alarm
Select an alarm.
No tone . . . . Does not sound.
High tone . . . High alarm sounds.
Low tone . . . Low alarm sounds.
+ m - 3 - 0
Keypad Sound
Setting Keypad Sound
< >
Information
p
The sound volume for keypad sound cannot be changed.
p
If you set this function to “OFF”, the battery level tone (see
page 44) and respective warning tones do not sound.
p The keypad does not make a sound when you press
. <
,
during ringing, or during playback of a moving image or i-
motion movie.
p When you press
. >
with your FOMA phone closed, the
FOMA phone works according to “Info notice setting” on
page 112.
Charge Sound
Setting Charging-start/end Tones
< >
Information
p The sound volume for charge sound cannot be changed.
p
The charging confirmation tone does not sound when a
display other than the Stand-by display is shown or during
Manner Mode or Public Mode (Drive Mode).
+ m - 7 - 5
Quality Alarm
Sounding Alarm when a Line is
Likely to be Disconnected
< >
Information
p
You might be disconnected without hearing an alarm if radio
wave conditions deteriorate suddenly.
p
An alarm for “Quality alarm” sounds only from the earpiece
during a videophone call.
You can set the duration of the ring tone which sounds
for incoming i-mode mail, SMS messages, Chat mail
and Messages R/F.
1
m
Settings Sound Mail/Msg. ring time
Select a type of mail or message
ON or OFF Enter a ring time (seconds).
p Enter in two digits from “01” through “30”.
You can set where you make the ring tone and alarm
sound from for when you connect the Flat-plug
Earphone/Microphone with Switch (option).
1
m
Settings Sound
Headset usage setting
H speaker or Headset only
+ m - 6 - 8
Mail/Message Ring Time
Setting Ring Time for Mail and
Messages R/F
< >
+ m - 5 - 1
Headset Usage Setting
Sounding Ring Tone from
Earphone Only
< >
Information
p
Even when you set “Headset only”, the ring tone sounds
from both the earphone and speaker about 20 seconds after
ringing starts. However, the tone does not sound from the
speaker but sounds from the earphone only even after 20
seconds have elapsed if the tone sounds for the operations
other than incoming calls, incoming mail, and alarm
notification.
p
Even when you set “Headset only”, the tone sounds from
the speaker when you do not connect the Flat-plug
Earphone/Microphone with Switch or when you start
shooting still or moving images.
p In the following cases, the tone sounds from the earphone
when the Flat-plug Earphone/Microphone with Switch is
connected, and from the speakers when it is not connected,
regardless of this setting.
・ During watching a One Seg program
・ During playback of a melody
・
During playback of an i-motion movie
・
During playback of a video file
・ While i-
α
ppli is running
・ During playback of a music file by MUSIC Player
・
During playback of a Music&Video Channel program
p Do not wind the cord of the Flat-plug Earphone/Microphone
with Switch around the FOMA phone.
p The FOMA phone may pick up noise if you take the cord of
the Flat-plug Earphone/Microphone with Switch close to the
FOMA phone during a call.