Operating Manual BKS600A
8
5
Quick Installation Guide
•
Check all your requirements such as:
– Control mode (edge left, edge right, center guiding)?
– Number and setup of the edge sensors?
– Steering device type (FMS steering frame, hydraulic drive or other device)?
(if a linear DC drive for unwind or rewind stands is used it must be setup; refer to
„9.7 Line-up of the limit positions and Offset Compensation“)
– configuration of the digital inputs and outputs?
– linking by interface etc.?
•
Draw your final wiring diagram according to the wiring diagram (refer to „7.2 Wiring
diagrams“)
•
Install and wire all your components (refer to „7. Installation and wiring“)
•
Turn power on and do the setup according to „8. Operating“
•
Proceed a test run with low speed
