Website
19
Note:
If using the Classic receivers you must select the [RX Interf ace] in the [RX SE
T] menu and select "i-BUS", sa
ve and
exit, then connect the sensor to the receiver's i-bus port. All other steps remain the same.
2.If you use an enhanced receiver, you need to set the New Port interface to ibus-in.
6.10 Sensor
This list shows all sensors connected to the receiver, including sensor type, number
and real-time data.This list can also be accessed quickly from the home screen.
[Display Sensors]：
This list shows all sensors connected to the receiver, including sensor type, number
and real-time data. This list can also be accessed quickly from the home screen.
[Type] shows the sensor type.
[ID] display sensor's number.
•
The number zero in the list by default is the TX Voltage sensor, however
receiver, signal strength indication, RSSI, noise, signal to noise ratio can also
take this slot.
•
No. 1 is the return information of the sub-receiver.
•
No. 2 is the first external sensor connected to the receive, the receiver supports
up to 14 sensors.
This list data is displayed in real time. When the receiver is connected to a sensor, this
list will be refreshed to display the new sensor’s data.
[Value] displays the data returned by a sensor.
Temperature Sensor（FS-CTM01）
Used to monitor the temperature of various components. Warnings can be set.
1.Connect the FS-CTM01 to the receiver or other sensors using the same method as used with other sensors.
2.Use a spongy double-sided tape to stick the temperature probe to the part you wish to monitor
(such as: motor,
battery).
3.Turn on the transmitter, enter [Sensor], then [Display Sensors] and rotate the wheel. If the “Type” column
displays “Temperature” and the [Value] column displays a temperature then the installation was successful,
otherwise repeat the above steps.
Voltage sensor (FS-CVT01)
It is used to monitor the model’s battery voltage. The battery voltage can be monitored through from the
transmitter. Warnings can be set.
1. Conn
ect FS-CPD02 following the same steps as above.
2. Insert the red and black wire pins into the plug of the battery used for testing. The red wire is the positive pole
and the black wire is the negative pole. When the voltage displayed on the transmitter sensor display interface is
positive, the installation is successful.
3. Turn on the transmitter, enter [
Sensor
] , then [Display Sensors] menu and rotate the wheel. If the “Type”
column displays “External Voltage” and the [Value] column displays a voltage then the installation was successful,
otherwise repeat the above steps.
FS-CPD02
FS-CTM01
FS-CVT01
FS-CPD01
FGr8B
FS-CPD02
FS-CTM01
FS-CVT01
FS-CPD01
FGr4B
