Website
31
7 RX SET
7.1 Bind Set
This function is used to adjust the transmitter to the bind state so that it can bind with the receiver.
Noble Pro supports a dual-receiver mode.
The ex-factory bind settings of the transmitter and receiver are completed successfully.
Enhanced version (take FGr8B as an example):
In the use of an enhanced receiver, if one receiver cannot meet the demand, you can use
the dual-receiver mode.
1. Press the Bind button on the receiver for seconds, and then connect the power cord
to any interface on the receiver. At this time, the receiver will flash quickly.
• Please make sure your transmitter is not connected to other receivers before binding.
2. Turn on the transmitter. Click the icon and enter the [RX SET], and select [Bind Set] in
the menu.
3. Click [Enhanced Receiver]. The system prompts "After switching you need re-binding,
Are you sure?". Click [Yes]
4 Click [Set start channel]. Click the right side of the corresponding channel. After
selection, this channel will become the first channel to receive transmitter signals.
Click to return to the previous level interface.
5. Click [Start bind]:
• When the RF standard selection is AFHDS3 two-way, the receiver indicator is on,
indicating the bind is successful. The transmitter will automatically exit the bind
interface.
• When the RF standard selection is AFHDS3 one-way, the receiver indicator flashes
slowly. Click to exit the transmitter bind interface. After the exit, the receiver indicator
is on, indicating the bind is successful.
6. The bind is successful. Take off the power cord from the receiver.
7. Reconnect the power cord to the receiver. Check whether the servo is working
properly. If a bind is required again, repeat the above steps.
•
If you want to use the dual receiver mode, click the check box on the right side of
[Dual Receiver Mode]. The icon will change and then the transmitter will enter dual
receiver mode. After selection, bind the transmitter with the primary receiver and the
secondary receiver in turn.
If you need to re-bind, please follow the following steps for the bind between the transmitter and receiver.
Classic version (take FGr4P as an example):
Classic receiver mode is only applicable to adaptations between the transmitter and receivers such as FGr4,
FGr4S, FGr4P, FTr4, FTr10 and FTr16S.
1. Insert the bind cable into the receiver's bind port,and plug the power cable into any other port. At this time,
the receiver will flash quickly.
2. Turn on the transmitter.Click the icon and enter the [RX SET], and select [Bind Set] in the menu.
3. Click [Classic receiver]. Click [Start bind]:
• When the RF standard selection is AFHDS3 two-way, the receiver indicator is on, indicating the bind is
successful. The transmitter will automatically exit the bind interface.
• When the RF standard selection is AFHDS3 one-way, the receiver indicator flashes slowly. Click to exit the
transmitter bind interface. After the exit, the receiver indicator is on, indicating the bind is successful.
4. The bind is successful. Take off the bind line and power cord from the receiver.
5. Reconnect the bind line and power cord to the receiver. Check whether the servo is working properly. If a
bind is required again, repeat the above steps.
