Website
21
Channel speed-back/brack
This function is only applicable to normal mode. This function is not displayed in ship
mode.
Function setting:
[Go Speed]: sets the speed of the throttle brake.
[Return speed]: sets the speed at which the throttle brake returns to the center position.
1. Click [Go Speed] or [Return Speed]. This item is highlighted when selected.
2. Click the "+" or "-" icon to change the response duration as needed. Press the "+" or "-"
icon to accelerate adjustment duration.
3. Verify that settings are normal as expected.
Progress bar 1: shows the channel output speed after the delay
(as shown on the left)
.
Progress bar 2: shows the actual speed before the delay takes effect
(as shown on the
left)
.
6.11 CH SPEED
This function allows you to set the steering speed, forward speed, brake speed and
response speeds of CH3 to CH18.
Note: the number of channels controlled is subject to the [Channel Number Definition].
[Steering Speed]: changes the corresponding speed of the servo when the steering
channel is outputting at fast speed. The minimum delay is 0.00s, and maximum delay
is 10.00s. The adjustment step is 0.01s.
This function can be used for adjustment when the vehicle is operated with fast
steering, which may cause the vehicle to lose control or when the vehicle structure
cannot withstand a too fast steering speed.
[Front ]: sets the response speed of the throttle channel.
This function can be used to imitate models with slow acceleration and deceleration
response (for example, large trucks).
[Back ]: used for vehicle models.
[Steering Speed], [Throttle] and [Brake] can be adjusted by assigning VR and TR type
buttons or knobs under the [Button Setting] function. A window pops up to prompt
real-time values in the adjustments by pressing buttons.
Forward speed
Turning speed
Start speed
Back to center speed
Channel speed - Steering
Function setting:
[Turn speed]: slows down channel output speed when the steering wheel is
moving from the neutral position to maximum travel.
[Return speed]: slows down channel output speed when the steering wheel
returns to the center position.
1. Click [Turn Speed] or [Return Speed]. This item is highlighted when selected.
2. Click the "+" or "-" icon to change response duration as needed. Press the "+"
or "-" icon to accelerate the adjustment duration.
3. Verify that the settings are normal as expected.
Progress bar 1: shows the channel output speed after the delay
(as shown on the
right).
Progress bar 2: shows the actual speed before the delay takes effect
(as shown
on the right).
Progress
bar 1
Progress
bar 2
