Pro
Website
18
[Model Reset] : To reset a model touch "Model reset", then select the model you wish to reset from the list. The
system will ask if you are sure, select "yes".
[Copy Model]: Touch "Copy Model", then touch the model to copy from the list. Next select a target slot from the list,
this will overwrite everything in that slot. The system will ask if you are sure, select yes.
[Import or Export Model] : You can import and export models by logging in to the FlySky official website to
download the software (FlySky Assistant) and then operate it on the PC (No need go back to click the menu on the
transmitter, you can operate it directly)!
Change the RF protocol:
1. Click [RF standard] to enter the submenu. Click the right side of the corresponding function. Select "Yes" and click
to return to the previous level interface after the prompt box pops up.
• If you switch to the RF standard, the model will be reset and a bind is required again.
[Update RF]:
The update RF function can be used to update the built-in RF module. After the firmware of the transmitter is
updated, you need to update the RF when the system prompts that the RF fails or the bind of the receiver fails.
Click [Update RF], Click "Yes" after the prompt interface pops up. An update progress bar appears. Wait a few
seconds. The update is completed. The transmitter will automatically exit the update interface. If the transmitter
cannot enter the update RF status, there is no RF module or the RF module is faulty.
[Custom main menu]: You can customize the main menus sorting of and visibility of functions. Touch the small box,
to select (show it in the menu) or deselect (hide from menu) If you need to adjust the menu order, select the menu
you want to move (highlight is selected), then touch [Move up] and [Move down] to change its position in the menu.
4. Connect the power cord to the transmitter. Press the receiver bind key while connecting the receiver power
supply. At this time, the receiver LED indicator flashes quickly.
• Operation modes vary with receivers in case of their bind state.
5. Click [Receiver setup]. Select [Bind setup]. After the receiver flashes slowly, the transmitter will automatically exit
the bind state. When the receiver indicator is on, it indicates the bind is successful.
6. Check whether the servo is working properly. If a bind is required again, repeat the above steps.
