Pressure
Controller/Calibrator
Module Guide Rails
43
Install the B-Series Valves
1. Use a #2 Phillips screwdriver and 4 screws
to install the base
into the
manifold (use guide hole on base for orientation). Torque to 8 in/lbs. See
Figure 23.
2. Install O-ring
into the base.
3. Place the valve body
into the valve shaft
. Ensure that the blue material
(seat) of the valve body is facing out to show that when the valve shaft
is
screwed into the base, that the seat material is making contact with the orifice
on the base.
4. With a large flat-head screwdriver, secure the valve shaft and body into the
base.
5. Place the coil washer
over the valve shaft with the rubber face up.
6. Place the coil
over the valve shaft, install the coil nut
,
and tighten it with
a 9/16 inch wrench or nut driver (do not over torque).
8
7
6
5
4
3
2
1
hxn216.eps
Figure 23. Install B-Series Valve
Summary of Contents for 6270A
