Flavor Burst FB 80Sa-08, Manual

Page: 46 / 76

45
Installing the Spigot Switch Assembly
Figure 103
To activate the Flavor Burst system, a switch
must be installed on the freezer draw-handle.
Every FB 80Sa system ships with a standard
Spigot Switch Assembly common to most
freezers. (See Figure 103.)
Should your freezer require an alternate switch
style, contact your local distributor for more
information.
NOTE: IF YOUR UNIT INCLUDES AN
ALTERNATE SPIGOT SWITCH, REFER TO
INSTRUCTIONS INCLUDED WITH IT FOR
PROPER INSTALLATION.
1. Determine the proper assembly and position
of the Switch and Switch Bracket
appropriate for your freezer model. When
possible, mount the Switch directly onto the
face of the freezer. If this is not possible,
configure the Bracket so that the Switch is
in the proper position. (See Figure 104.)
Figure 104
NOTE: THE SWITCH MUST BE POSITIONED
SO THAT THE SWITCH LEVER IS FULLY
DEPRESSED WHEN THE DRAW HANDLE IS
IN THE OPEN POSITION. (See Figure 105.)
Figure 105
2. If using the Bracket, assemble the Bracket
and the Switch using the appropriate
pieces. If both bracket plates are used,
ensure the lock washer is installed between
them. Use some of the adhesive included
to attach the Switch to the Bracket. (See
Figure 106.)
Figure 106
3. Attach a moderate portion of the adhesive
to the side of the Switch or Bracket that will
be secured to the freezer face. (See
Figure 107.)
Figure 107