50
1. Assemble the Mounting Bracket as shown.
Insert the screw through the front bracket,
then through the spring washer and finally
through the back latch bracket. Secure the
assembly with the nut and tighten. (See
Figure 128.)
Figure 128
2. Rotate the back latch bracket so that it is
perpendicular to the front bracket. This is
the “open” position. (See Figure 129.)
Figure 129
3. Install the Blending Head fully over the
Blending Adapter so that the locking collar
covers the tabs on the Adapter. Rotate the
locking collar to secure. (See Figure 130.)
26042
Figure 130
4. Install the Mounting Bracket over the
Blending Assembly motor and onto the door
post. Ensure the bracket hangs directly
below the door post. (See Figure 131.)
26040
Figure 131
5. Swing the back latch bracket down to close
the bracket behind the Blending Assembly
and around the door post. (See
Figure 132.)
Figure 132
6. Ensure the two bracket plates connect
through the slots at the lower ends of the
plates. (See Figure 133.)
Figure 133
Summary of Contents for FB 80Sa-08
