Flavor Burst FB 80Sa-08, Manual, Page: 20 / 76

19
The following do not need to be sanitized on a
daily basis as part of the daily opening
procedures. However, inspect these areas and
if necessary, clean according to instructions in
the SCHEDULED MAINTENANCE section:
(See Figure 12.)
•
9-Tube Assembly Coupler
•
9-Tube Assembly Tubes
•
Spigot Switch
•
Keypad and Keypad Bracket
•
Blending Adapter (clean according to
instructions when freezer door has been
removed)
•
Outer surfaces of Blending Motor
•
Exposed surfaces of Cabinet
•
Mounting Bracket
26011
Figure 12
Installing the Blending System
The Blending Head syrup port o-ring is a wear
item and will need to be replaced periodically.
Check for wear occasionally and always keep a
spare on hand in the Spare Parts Kit.
1. Install the Blending Head fully over the
Blending Adapter so that the locking collar
covers the tabs on the Adapter. Rotate the
locking collar to secure. (See Figure 13.)
26042
Figure 13
2. Open the Mounting Bracket and install it
over the Blending Assembly and onto the
door post. (See Figure 14.)
26040
Figure 14
3. Close the bracket over the door post and
behind the Blending Assembly. (See
Figure 15.)
26084
Figure 15
4. Insert the 9-Tube Assembly manifold fully
into the Blending Head syrup line opening.
Rotate it until motion stops to secure. (See
Figure 16.)
26044
Figure 16