Flavor Burst FB 80Sa-08, Manual

Page: 43 / 76

42
9-Tube Assembly Syrup Lines
Figure 96
1. If it is necessary, follow instructions in
‘Phase 1’ and ‘Phase 3’ of the Clean-In-
Place procedure to clean and sanitize the
Coupler Body, Syrup Line Manifold, and the
Duckbill Check Valve.
2. Clean the Coupler Base, the end of the
syrup lines and the outside of the syrup
tubes with a single service towel moistened
with detergent water.
3. Rinse the parts using a single service towel
and warm water, then dry with a dry single
service towel.
4. Reassemble the 9-Tube Assembly if
necessary according to instructions.
Winterizing the Unit
If you will not be using your Flavor Burst
®
system during the off-season or other extended
periods of time, you should winterize the
FB 80Sa system as a precautionary practice to
avoid damage or undesirable syrup build-up in
the unit.
NOTE: YOU DO NOT NEED TO USE
ANTIFREEZE SOLUTION IN THIS SYSTEM
WHEN WINTERIZING THE UNIT.
1. Perform the Clean-In-Place procedure as
instructed, except do not reconnect the
Connectors to the syrup bags.
2. Remove each syrup bag from its tray and
store as directed on the label. (See
Figure 97.)
26190
Figure 97
3. Empty all the sanitizer solution from the
Sanitizer Tank. (See Figure 98.)
Figure 98