Flavor Burst FB 80Sa-08, Manual, Page: 53 / 76

52
Mounting the Accessory Hanging Bracket
The Accessory Hanging Bracket is used to
suspend the Blending Assembly and 9-Tube
Assembly while other parts of the system have
been removed for cleaning. The Accessory
Hanging Bracket should be mounted in an
accessible area 6 in. or more above the 9-Tube
Assembly Casing. This will allow enough room
for the Blending Assembly to hang properly.
1. Mix approved detergent with warm water
according to manufacturer’s instructions.
2. Determine the approximate area where the
Bracket will be attached on the side of the
freezer. The Bracket should be attached on
the side the 9-Tube Assembly tubes wrap
around to the back of the freezer. It should
also be installed level just below the Keypad
Bracket.
3. Clean, rinse and dry thoroughly the area on
which the Bracket will be mounted using
detergent water, clean water, and single
service towels. (See Figure 140.)
Figure 140
4. Remove the protective adhesive tape from
the adhesive strip on the Bracket. (See
Figure 141.)
Figure 141
5. Mount the Bracket to the desired area on
the freezer. (See Figure 142.)
26182
Figure 142
6. The 9-Tube Assembly slides into the
smaller slot on the Bracket so that the
coupler casing is above the bracket and the
syrup tubes hang below. (See Figure 143.)
26187
Figure 143
7. The Blending Motor hangs on down the
larger slot, so that the locking collar slides
above the bracket, and the rest of the
Blending Assembly hangs below it. (See
Figure 144.)
26186
Figure 144