Flavor Burst FB 80Sa-08, Manual

Page: 25 / 76

24
6. With the Blending Head tilted downward,
brush and clean all exposed surfaces of the
Blending Head with detergent water and
then rinse thoroughly. Use a small brush to
ensure that the syrup orifices are clear of
any residual syrup. (See Figure 28.)
26064
Figure 28
NOTE: DO NOT EXPOSE THE DRIVE
MOTOR TO MOISTURE.
7. Place only the Blending Head portion of the
Assembly in a container of detergent water.
Keep the Drive Motor upright and just above
the water line. Press the WATER / SYRUP
FLUSH key to clean the blending auger
inside the Blending Head. (See Figure 29.)
WATER
LINE
DRIVE
MOTOR
Detergent
26063
Figure 29
8. Place only the Blending Head portion in an
approved sanitizer solution, keeping the
Drive Motor above the water line. Press
WATER / SYRUP FLUSH to sanitize the
auger. Allow the Blending Head to soak for
at least 1 minute. (See Figure 30.)
WATER
LINE
DRIVE
MOTOR
Sanitizer
26066
Figure 30
9. Remove the restrictor disc from the sanitizer
and place it in the Blending Head. (See
Figure 31.)
26059
Figure 31
10. Place the cap on the 9-Tube Assembly and
hang it with Blending Assembly the
Accessory Hanging Bracket to dry. (See
Figure 32.)
26186
Figure 32
11. Clean, rinse and dry the surfaces of the
Blending Motor, the Keypad, and exposed
surfaces of the cabinet using detergent
water, clean water, and single service
towels. (See Figure 33.)
Detergent
Water
RINSE
26014
Figure 33