Flavor Burst FB 80Sa-08, Manual

Page: 37 / 76

36
3. Fill the Sanitizer Tank with approved
sanitizer solution (See Figure 73.)
Figure 73
NOTE: USE THE REMAINING SANITIZER
SOLUTION FOR MANUAL SANITIZING IN
THE CLEAN-IN-PLACE PROCEDURE, DAILY
OPENING PROCEDURES, OR DAILY
CLOSING PROCEDURES.
4. Reinstall the hand pump and tighten
sufficiently. Using the handle, pump air into
the Sanitizer Tank to prime the pump
(approximately 10 strokes.) (See
Figure 74.)
Figure 74
NOTE: NO PRESSURE IS NEEDED IN THE
TANK DURING NORMAL OPERATIONS.
Cleaning the Spout Adapter
The Spout Adapter does not require daily
cleaning under normal operating conditions.
Since the fitting is very tight, install the Adapter
with the freezer door removed. Therefore,
clean only as needed or when disassembling
the freezer door for cleaning (approximately
every 2 weeks). Replacement o-rings and
gasket are available in the Spare Parts Kit.
1. Mix approved detergent with warm water
according to manufacturer’s instructions.
Also, prepare approved sanitizer solution
according to manufacturer’s instructions.
2. Remove the Spout Adapter from the freezer
head. Since the fitting is very tight, you may
need to use a small tool to pry the Adapter
from the door spout. (See Figure 75.)
Figure 75
3. Remove the two black o-rings from the
Spout Adapter. (See Figure 76.)
Figure 76