Fike 10-071, Installation Manual

Page: 42 / 76

3.0 SYSTEM COMPONENTS
3-24 Cheetah Xi 50 Installation Manual UL S2203
Rev 6, 09/2015 P/N: 06-369 FM
3.12 BATTERIES AND BATTERY ENCLOSURES
Batteries are required for alarm systems for maintaining emergency back-up power. Two each 12V batteries
are required and are to be wired in series for maintaining a 24VDC back-up. Most systems require at least a
24 hour standby current with 5 minutes alarm current for determining minimum battery size. Refer to
Appendix A for Battery Calculation form for determining required battery size for system.
3.12.1 BATTERY ASSEMBLIES
P/N 10-2626 – Two 12 AH batteries with wire harness
P/N 10-2190-2 – Two 18 AH batteries with wire harness
P/N 10-2192 – Wire harness for 7.2 AH and 18 AH batteries
P/N 10-2517 - Wire harness with Battery EOL (for use if
batteries give fault but load test good)
3.12.2 BATTERIES
Two 12 volt batteries wired in series are required to maintain
24 Vdc backup.
P/N 02-2018 7 AH Battery
P/N 02-4622 12 AH Battery
P/N 02-2820 18 AH Battery
P/N 02-3468 33 AH Battery
P/N A02-0252 40 AH Battery
P/N 02-4206 75 AH Battery
3.12.3 BATTERY ENCLOSURES
Batteries larger than 18 AH will not fit inside the Cheetah Xi
50 panel enclosure(s); therefore, one of the following battery
enclosures must be installed to house the batteries.
Interconnecting cables from the battery cabinet to the
Cheetah Xi 50 enclosure shall be in installed in conduit.
3.12.3.1 33AH BATTERY ENCLOSURE
(BATTERIES NOT INCLUDED)
P/N 10-2154-c (c = R ed or B lack)
The 33AH Battery Enclosure (See Exhibit 3-52) is a heavy
gauge metal enclosure designed to house two 33AH
batteries. Conduit knockouts are provided to provide entry
of battery wiring. The box lid is installed onto the back-box
using the 4 mounting screws provided.
Refer to Fike document 06-534 for more information.
3.12.3.2 75AH BATTERY ENCLOSURE
(BATTERIES NOT INCLUDED)
P/N 10-2236-c (c = R ed or B lack)
The 75AH Enclosure (See Exhibit 3-53) is a heavy gauge
metal enclosure designed to house two 75AH batteries.
Conduit knockouts are provided to provide entry of battery
wiring. The box lid is installed onto the back-box using the 4
mounting screws provided.
Refer to Fike document 06-535 for more information.
Exhibit 3-52: 33AH Battery Enclosure
Exhibit 3-53: 75AH Battery Enclosure
Exhibit 3-51: Sealed Batteries