FICEP 1001 DFB, Programming And Operating Manual

Page: 97 / 226

Model 1001 DFB Programming and operating manual
FICEP S.p.A. 97
Verifying the correct axes displacement
At any moment it is possible to check if the true covered distance by an axis corresponds with the pro-
grammed displacement.
To do that follow the procedure below.
1. In the “Execution” window read the coordinate of the axis to check; if the coordinate is not present
open the jog window and select the desired axis;
2. Write the coordinate on a sheet of paper;
3. Visibly scratch on a fixed part of the machine a reference mark corresponding to a chosen point of
the axis;
4. Move the axis in manual mode till any other position;
5. Read the new coordinate of the axis;
6. Note on the sheet the new coordinate;
7. Visibly scratch on the same fixed part of the machine the new position of the same chosen point of
the axis;
8. Calculate the absolute value of the difference between the two coordinates;
9. Measure with a meter (or, better, with a callipers) the distance between two marks;
10. Calculated value and measured value must be exactly the same.