FICEP 1001 DFB, Programming And Operating Manual

Page: 112 / 226

Programming and operating manual Model 1001 DFB
112 FICEP S.p.A.
APPENDIX A – DIAGNOSTICS
List of more frequent signals
More frequent alarms (red messages)
009 A value of parameters or cycles has been modified; it is necessary switch off and switch on
again the CNC
030:n Alarm encoder signals for axis "n"; no 24 V DC for encoder or cable interrupted or encoder out
of order
037 CAN Bus alarm; resync required
040:n Axis "n" alarm; bar weight to heavy per X axis or axis driver out of order
046:n
Axis “n” not answering
050:n No power 24 V DC on Output electronic board “n”; interrupted fuse or wire
070
Collision
080:00 Auxiliary circuits not activated; automatically cleared when auxiliary circuits are activated
More frequent messages (yellow messages)
010:n Min. barrier axis “n”; a movement further the minimum coordinate is required
013:n Program “n” selected not OK
015 Enable for zero cycle not present; probably an axis is out of barrier
020:n Max. barrier axis “n”; a movement further the coordinate is required
023:n Timeout for service movement (n = cause, F.I. vices not closed in time)
034:n Timeout for marking operations (n = cause, F.I. end of work, wrong character, etc…)
036 Update required for machine setup; the operator must confirm
038:n Phase “n” not OK during zero cycle (n = n. phase)
115:n Bar wrong position while catching material (n = cause, F.I. automatic measuring of bar length
required with busy photocell)
118:n “Start cycle” not possible because the pincher (n = cause, F.I. open or lifted pincher, etc…)
220:n Marking operation not available for barrier X/LP
More frequent errors (gray messages)
012 Incorrect data
013 Stand-by mode requested
036 Tool selection not OK
039 Tool not configured
067 Not possible selection
096 Canonic program not more executable because remaining bars are equal to zero
151 Nesting not OK
280 Profile already existing
281 Material already existing
340 Tool not found in PAF table; a tool not known by CNC has been programmed