FICEP 1001 DFB, Programming And Operating Manual

Page: 196 / 226

MACHINE SET-UP
Page 4-12
1001 DFB
Drilling & Sawing Line
FICEP
4.3.7 Pincher jaws replacement
The type of jaws to be used depends upon the type and thickness of the section to be
handled and the operation to be performed.
Remove the pin passing within the stationary and mobile jaw and replace the top jaw.
Make sure to fit the pin back to its seat.
Special pincher to meet specific requirements can be supplied on request, after their
application has been thoroughly discussed with our Technical Division Engineers.
Top mobile jaw Drwg. N° 7 0 6 6 1 2
thickness from 3 to 15 mm.
Top mobile jaw Drwg. N°
7 0 6 6 1 3
thickness from 15 to 27 mm.
Top mobile jaw Drwg. N°
7 0 6 6 1 4
thickness from 27 to 39 mm.
Top mobile jaw Drwg. N° 7 0 6 6 1 5
thickness from 39 to 50 mm
Top mobile jaw Drwg. N° 7 0 7 4 7 5
thickness from 50 to 75 mm
Top mobile jaw Drwg. N° 7 0 7 4 7 6
thickness from 75 to 100 mm
Bottom stationary jaw Drwg. N° 7 0 6 6 1 1