Festo CMMS-AS-G2 Series, Description

Page: 146 / 174

A Diagnostic messages
146 Festo – GDCP-CMMS-AS-G2-FW-EN – 1310NH – English
Error group 04 Temperature monitoring, electronics
No. Code Message Reaction
04-0 4210h Excess/low temperature of power electronics Configurable
Cause Motor controller is overheated.
– Motor controller overloaded?
– Temperature display plausible?
Measure • Check installation conditions, cooling through the housing
surface, integrated heat sink and back wall.
• Check the drive layout (due to possible overloading in continu-
ous operation).
Error group 05 Internal voltage supply
No. Code Message Reaction
05-0
5114h
5 V electronics supply fault
PS off
Cause Monitoring of the internal power supply has recognised under-
voltage. This is either due to an internal defect or an overload/
short circuit caused by connected peripherals.
Measure • Separate device from the entire peripheral equipment and
check whether the error is still present after reset. If so, an
internal defect is present Repair by the manufacturer.
05-1 5115h Error in 24 V supply PS off
Cause Monitoring of the internal power supply has recognised under-
voltage.
Measure • Check 24 V logic supply.
• Separate device from the entire peripheral equipment and
check whether the error is still present after reset. If so, an
internal defect is present Repair by the manufacturer.
05-2 8000h Error in driver supply PS off
Cause Error in the plausibility check of the driver supply (Safe Torque Off )
Measure • Separate device from the entire peripheral equipment and
check whether the error is still present after reset. If so, an
internal defect is present Repair by the manufacturer.
Error group 06 Intermediate circuit
No. Code Message Reaction
06-0 2320h Over-current of the intermediate circuit/output stage PS off
Cause – Motor defective.
– Short circuit in the cable.
– Output stage defective.
Measure • Check motor, cable and motor controller.