27
Installing the Mobile Camera System
orientation, connect the camera to the monitor with a camera
extension cable (one CAMCABLE-SHORT/-5/-10/-15/-20/-40
or two connected in series with CAMCABLE-EXT) or special
DVR system camera cable (as applicable). It may be necessary
to rotate the camera in the mounting bracket to obtain the cor-
rect orientation. Once you obtain the image you want, tighten the
screws on the mounting bracket to fix the camera position.
4. Wrap the cable connection in the supplied black waterproofing
tape.
Installing the Dome Camera (CAMCCD-DOMENTSC/
CAMCCD-DOMEPAL)
Before the installation, find an appropriate location for the dome camera
with these considerations in mind:
• This camera is intended for only indoor use. Installing it on the
exterior of a vehicle is not recommended.
• The material properties and thicknesses of vehicle bodies vary widely.
The included hardware can accommodate many different vehicle
installations. However, it is recommended you exercise judgment
when drilling holes into vehicle surfaces.
• When drilling into a vehicle structure, be sure that both sides of the
surface are clear of anything that could be damaged. Remove all burrs
from drilled holes. To prevent electrical shorts, grommet all drilled
holes through which wiring passes (all Federal Signal cameras include
grommets). Also, ensure that the mounting screws do not cause
electrical or mechanical damage to the vehicle.
• This camera is recommended for installation in vehicle interior
spaces like the cargo bay of a delivery vehicle. The camera should
be positioned so that the driver can obtain a wide, unobstructed
field of vision.
To install the dome camera, follow these steps:
Preparing to Install the Dome Camera
1. Open the included camera mounting hardware kit, which has:
• Four self-tapping screws
•
Four machine screws with matching lock washers, flat washers,
and nuts
