20
Installing the Mobile Camera System
a) If you are using the self-tapping screws, drill two to four
0.089 in (2.2 mm) holes (a #43 drill bit can be used).
b) If you are using the machine screws, drill two to four 1/8 in
(3.2 mm) clearance holes.
4. Drill a 3/4 in (19.0 mm) hole at the mark for the camera output
cable. Smooth and deburr the hole.
290A6048B
OPTION 1: MOUNTING BRACKET
OPTION 2: FLUSH MOUNT
MOUNTING SURFACE
NUT
2 TO 4 MACHINE SCREWS
WITH LOCK WASHERS,
FLAT WASHERS AND NUTS
Figure 3. Options for mounting flush-mount camera
(CAMCCD-FLSHNTSC/CAMCCD-FLSHPAL)
Option 2: Marking and drilling holes for mounting the flush-
mount camera flush to the vehicle surface
1. Mark a location for the 1.25 in (32.0 mm) mounting hole on the
vehicle surface that will accommodate the full diameter and depth
of the camera body. Once you drill this hole, you can route the
camera output cable to:
a) a camera-to-monitor extension cable that can be either
• one CAMCABLE-SHORT/-5/-10/-15/-20/-40 or
• two CAMCABLE-SHORT/-5/-10/-15/-20 connected in
series with adapter CAMCABLE-EXT
that is then connected to
• either the
CAM1
or
CAM2
input on the input/pow-