12
Installing the Mobile Camera System
Mounting the Rear-View Camera
1. Install the insulating pad on the bottom of the camera mounting
bracket. If you are using the center hole in the bracket for the
camera output cable, route the cable through the hole.
2. Align the mounting bracket with the drilled mounting holes,
guide the camera output cable into the 3/4 in (19.0 mm) hole,
and secure the rubber grommet in the hole.
3. To fasten the mounting bracket to the vehicle, choose the appro-
priate screws for the mounting holes you drilled:
a) If you are using the self-tapping screws, guide each screw
through a plastic insulator, then through one of the two chan-
nels in the mounting bracket and into the drilled holes. Fas-
ten the screws tightly to the vehicle body.
b) If you are using the machine screws, guide each screw through
a plastic insulator, then through one of the two channels in the
mounting bracket into the drilled holes. On the opposite side
of the vehicle chassis at the mounting location, install the flat
washer followed by the lock washer and nut. Fasten the mount-
ing hardware tightly to the vehicle body.
4. Connect a one of these camera extension cable to the camera:
• one CAMCABLE-SHORT/-5/-10/-15/-20
• two CAMCABLE-SHORT/-5/-10/-15/-20 connected in series
with adapter CAMCABLE-EXT
• one CAMCABLE-40
• special DVR cable (as applicable)
5. Wrap the cable connection in the supplied black waterproofing
tape.
