30
Installing the Mobile Camera System
3. Drill a 3/4 in (19.0 mm) hole at the mark for the camera output
cable. Smooth and deburr this hole.
290A6050B
4 SELF-TAPPING SCREWS OR MACHINE SCREWS WITH LOCK
WASHERS, FLAT WASHERS AND NUTS
REMOVE THE 4
SCREWS SECURING
THE HOUSING
SECURE THE MOUNTING
HARDWARE THROUGH
THE HOLES IN THE BASE
TO AIM THE CAMERA,
LOOSEN THE 2 ADJUSTMENT
SCREWS, ADJUST THE AIM,
AND TIGHTEN THE SCREWS
Figure 5. Dome camera installation CAMCCD-BALLNTSC/CAMCCD-BALLPAL
Mounting the Dome Camera
1. Align the mounting base on the vehicle with the drilled mounting
holes and guide the camera output cable into the 3/4 in (19.0 mm)
hole.
2. To affix the camera to the vehicle, choose the appropriate screws
for the mounting holes you drilled:
a) If you are using the self-tapping screws, guide each screw
through the camera base, then into the drilled holes. Fasten
the screws tightly to the vehicle body.
b) If you are using the machine screws, guide each screw with its
lock washer and flat washer through the camera base. Install
the matching nut on the opposite side of the vehicle surface.
Fasten the mounting hardware tightly to the vehicle body.
3. Connect a camera extension cable (one CAMCABLE-SHORT/
-5/-10/-15/-20/-40 or two connected in series with CAMCABLE-
EXT) or special DVR cable (as applicable) to the camera.
