29
Installing the Mobile Camera System
DRILLING PRECAUTIONS
When drilling holes, check the area into which you are drilling to
be sure you do not damage vehicle components while drilling. All
drilled holes should be deburred and all sharp edges should be
smoothed. All wire routings going through drilled holes should be
protected by a grommet or convolute/split loom tubing.
1. Use the mounting base as a guide to mark the locations of four
mounting holes on the vehicle chassis and a 3/4 in (19.0 mm)
hole for the camera output cable. Once this hole is drilled, you
can route the camera output cable through it to:
a) a camera-to-monitor extension cable that can be either
• one CAMCABLE-SHORT/-5/-10/-15/-20/-40 or
• two CAMCABLE-SHORT/-5/-10/-15/-20 connected in
series with adapter CAMCABLE-EXT
that is then connected to:
• either the
CAM1
or
CAM2
input on the input/pow-
er/trigger wiring harness (CAMADP-INT-2) of the
CAMLCD-INT-56/CAMLCD-INT-70 monitor
or
• one of the four camera inputs on the CAMBOX-
4NTSC/CAMBOX-4PAL control box (for use with the
CAMLCD-70 monitor)
or
• one of the four camera inputs on the input/power/trigger
wiring harness (CAMADP-INT-4) of the CAMLCD-
INT-70-B
or
a) a special DVR system camera-extension cable that is con-
nected to one of the four camera inputs on the CAMDVR-4-B
2. Drill the correctly sized holes at the drill-position marks for the
type of screws you are using:
a) If you are using the self-tapping screws, drill four 0.116 in
(3.0 mm) holes.
b) If you are using the machine screws, drill four 5/32 in
(4.0 mm) clearance holes.
