11
Installing the Mobile Camera System
2. Mark a location for a 3/4 in (19.0 mm) hole, typically centered
between the marked locations of the mounting holes, which will
accept the rubber grommet on the camera output cable. Once
you drill the center hole, you can route the camera output cable
through it to:
a) a camera-to-monitor extension cable that can be either:
• one CAMCABLE-SHORT/-5/-10/-15/-20/-40
or
• two CAMCABLE-SHORT/-5/-10/-15/-20 connected in
series with adapter CAMCABLE-EXT
• that is then connected to
• either the
CAM1
or
CAM2
input on the input/pow-
er/trigger wiring harness (CAMADP-INT-2) of the
CAMLCD-INT-56/CAMLCD-INT-70 monitor
or
• one of the four camera inputs on the CAMBOX-
4NTSC/CAMBOX-4PAL control box (for use with the
CAMLCD-70 monitor)
or
• one of the four camera inputs on the input/power/trigger
wiring harness (CAMADP-INT-4) of the CAMLCD-
INT-70-B
or
b) a special DVR system camera-extension cable that is con-
nected to one of the four camera inputs on the CAMDVR-4-B
3. Drill holes at the drill-position marks that are correctly sized for
the screws you are using:
a) If you are using the self-tapping screws, drill two to four
9/64 in (3.5 mm) holes.
b) If you are using the machine screws, drill two to four
13/64 in (5.2 mm) clearance holes.
4. Drill a 3/4 in (19.0 mm) hole at the mark for the camera output
cable. Smooth and deburr the hole.
