FE MONITOUCH V8 SERIES, Reference: Additional Functions

Page: 500 / 508

27 Ladder Transfer via USB or Ethernet
27-9
27
[Ladder Transfer Setting] in LadderComOp
1. For how to reach the [Ladder Transfer Setting] dialog, refer to “[Ladder Transfer Setting] in
LadderComOp” in “Ladder Transfer via USB” (page 27-7).
2. Check the box for [ COM port].
Select a COM port* which is not used by the software or tools in your computer. Select [Ethernet]
under [Transfer Port].
* The above [COM port] setting must be the same as the COM port setting in the ladder
software for the PLC. For more information, refer to “COM Port Setting for PLC” (page
27-10).
The range of the usable COM port numbers depends on the PLC programming software.
For more information, refer to the manual for your PLC.
Example: COM port Nos. 1 to 15 available with Panasonic FPWIN GR (COM ports limited to
Nos. 1 to 5 for version 2.2 or earlier)
3. The IP address must be the same as the V8 local port IP address. The [Port No.] must be the
same as the [Port No.]* in the [Device Connection Setting] dialog in the V-SFT.
* For more information, refer to “[Device Connection Setting] in V-SFT” (page 27-8).
4. The necessary settings have been completed.
When [ COM port] is checked, every serial communication that uses the COM port
you selected will be converted to communication via USB or Ethernet.
Therefore, be sure that the COM port selected under [COM port] is not already used for
other serial communications.
Except when ladder transfer via USB/Ethernet is used, uncheck the box for [ COM
port].
[Port No.]: 1024 - 65533 (1024 as default)