89
Jiefang J6 China IV, China V series instruction
Lu
b
rica
tin
g
o
il
Maintenance
Oil change cycle of each assembly
Engine every 10,000 km
Transmission every 50,000 km
Drive axle every 50,000 km or one year
Steering system every 20,000 km or half a year
Warning
⊙
In strict accordance with the regulations, the
lubricating oil that meet the standards are selected.
⊙
It is forbidden to mix different brands of
lubricating oil produced by different manufacturers.
Engine oil change
Park the vehicle on a flat surface and place
sliding resistance block at the wheel.
Under the state of hot vehicle (the oil temperature
is about 80
℃
), unscrew the oil drain plug on the
lower part of the oil pan (observe the oil heat, and
do not get burned ), and remove the impurities
absorbed by the plug.
Tighten the oil drain plug after the oil is drained.
Turn over the cab and will see the oil filler
opening. Add new lubricating oil so that the oil
level reaches the upper limit of the oil scale.
After the engine starts, idles for several minutes
and stops for 30min, check the oil scale and the oil
level shall be between the two marks.
Cycle for change engine oil
- When the running-in of new vehicle is over
(traveling 2500km).
- When driving every 10,000 km.
Normal
Too high
Too low
Summary of Contents for J6 Jiefang IV Series
