33
Jiefang J6 China IV, China V series instruction
S
witc
h
Bu
tto
n
H
a
n
d
le
Correct operation
ECAS drive help switch
- When the switch is pressed, the ECAS controller
is driven to control the float bridge to rise. When the
speed reaches the limit, the float bridge falls
automatically.
Floating bridge lift switch
- On the premise that the driving axle is not fully
loaded, press the switch to lift the pontoon. If the
float bridge lifting is successful, the float bridge
lifting indicator lights up on the instrument.
- Press this switch again, or when the driving axle
load exceeds the set load, the floating axle falls
automatically and the lifting indicator of the
floating axle goes out.
ASR mandatory switch
- Self-reset switch. When driving on ice and snow
road, press the switch. The controller receives the
trigger signal to control the anti-side-slip system,
and then press the first switch upward to relieve the
working state of the system.
Power takeoff switch
- Press this switch and the power takeoff lamp on
the dashboard will be ON. When the power takeoff
is in operation,
Parking power takeoff switch
- Press this switch and the power takeoff lamp on
the dashboard will be ON. When the power takeoff
is in operation,
Caution
⊙
When driving requires a PTO to work, it is
necessary to press the
PTO switch.
⊙
When parking requires a
PTO to work, it is
necessary to press the PTO switch and the
power take-off device.
Inductive load control switch
- When the switch is pressed, the floating bridge
brake solenoid valve is forcibly controlled to work.
Fuel preheating switch
- When the switch is pressed, the driving relay
controls the heating system of the oil pipe and the
fuel fine filter.
Caution
If the ambient temperature is above 0
℃
, the fuel
preheating switch must be closed.
PTO switch
- When the PTO switch is pressed, the engine works
at the target speed stored in advance by PTO, and
the throttle pedal loses its function.
- When PTO switch is pressed, the conversion
between manual throttle and pedal throttle is
realized. When the engine ECU responds to the
position sensor signal of the hand throttle, the
throttle pedal loses its function.
PTO adjusting increment switch
—
In the engine PTO mode, the engine speed is
increased by operating the PTO adjusting increment
switch (i.e, "Set+" signal). When the switch is
pressed at the point, the starting speed increases
according to the calibrated increment (50
revolutions per time). When the switch is pressed
for a long time, the engine speed rises linearly
according to the calibration slope (200 rpm/s). Press
and hold the button until the upper limit of the
engine PTO speed is calibrated.
PTO adjusting decrement switch
- In the engine PTO mode, the engine speed is
decreased by operating the PTO adjusting
decrement switch (i.e., "Resume-" signal). When
the press switch is pressed at the point, the engine
speed decreases according to the calibration
increment (50 rpm/time). When the switch is
pressed for a long time, the engine speed decreases
linearly according to the calibration slope (200
rpm/s) until the lower limit of engine PTO speed is
calibrated.
Summary of Contents for J6 Jiefang IV Series
