134
Jiefang J6 China IV, China V series instruction
Correct operation
Overturn mechanism of the cab
Warning
⊙
Before the cab is turned over, the vehicle shall
be parked on the horizontal surface, and the
transmission shall be placed in neutral position, and
the manual valve shall be pulled up, the door shall
be closed, and the outer panel of front wall shall be
open.
⊙
During the turnover and fall-back of the cab, no
body can be allowed in the front and rear of the cab.
⊙
The cab must be turned continuously until the
hydraulic cylinder is marked red before the overturn
operation can be stopped and the engine
compartment can be repaired.
In the process of cab overturn, the phenomenon of
fast falling and self-falling will occur at a specific
angle, which will not affect the safety and normal
use. At the moment, do not start the engine or carry
out any other operation.
⊙
After the cab falls back, it is necessary to
confirm that the cab is locked. The vehicle can be
driven only after confirming that the cab turnover
alarm lamp is off.
Caution
⊙
Before driving, the position of the reversing rod
on the oil pump should be checked and confirmed.
⊙
Be sure to keep the environment clean during oil
filling, so as to avoid dust, fiber, feather and other
foreign matters into hydraulic oil.
⊙
The working medium of the overturn
mechanism is No. 10 aviation hydraulic oil, and
other types of oil shall not be mixed.
⊙
When washing vehicles or repairing engines,
special attention should be paid to avoid damaging
oil pipes and wires in the system. No water is
allowed to enter the oil filling port of the oil pump.
⊙
The continuous operation of electric drive pump
shall not exceed five times (although the protection
circuit of motor is set internally, the excessive heat
will reduce the service life of the motor).
Summary of Contents for J6 Jiefang IV Series
