FAW J6 Jiefang IV Series, Operation Manual

Page: 160 / 217

152
Jiefang J6 China IV, China V series instruction Appendix and Data
S/N Text prompt content Recommended measures
5. Please go to the service station for maintenance.
49 Fault of input shaft sensor
1. It can be driven, and the fault rate of hanging start gears is high, and the impact is relatively heavy.
2. Please check whether the connector is loose or damaged.
3. If inserted many times, the plug-in may be oxidized and corroded or the terminal may be deformed due to the salt spray.
4. Visually check whether there is any damage on wiring harness or sensor.
5. Please go to the service station for maintenance.
50 Fault of clutch position sensor
1. It cannot be driven.
2. Please check whether the connector is loose or damaged.
3. If inserted many times, the plug-in may be oxidized and corroded or the terminal may be deformed due to the salt spray.
4. Visually check whether there is any damage on wiring harness;
5. Please go to the service station for maintenance.
51 Fault of shift position sensor
1. It cannot be driven.
2. Please check whether the connector is loose or damaged.
3. If inserted many times, the plug-in may be oxidized and corroded or the terminal may be deformed due to the salt spray.
4. Visually check whether there is any damage on wiring harness or sensor.
5. Please go to the service station for maintenance.
52 Fault of gear selection position sensor
1. It cannot be driven.
2. Please check whether the connector is loose or damaged.
3. If inserted many times, the plug-in may be oxidized and corroded or the terminal may be deformed due to the salt spray.
4. Visually check whether there is any damage on wiring harness or sensor.
5. Please go to the service station for maintenance.
53 Fault of auxiliary box position sensor
1. It can operate;
2. Please check whether the connector is loose or damaged.
3. If inserted many times, the plug-in may be oxidized and corroded or the terminal may be deformed due to the salt spray.
4. Visually check whether there is any damage on wiring harness or sensor.
5. Please go to the service station for maintenance.
54 The battery voltage is too low Please charge the battery.
55 The battery voltage is too high. Please replace the battery or repair it at the service station, otherwise it will burn TCU.
56 fault of air pressure sensor
1. It can operate;
2. Please check whether the connector is loose or damaged.
3. If inserted many times, the plug-in may be oxidized and corroded or the terminal may be deformed due to the salt spray.