185
Jiefang J6 China IV, China V series instruction
Correct operation
Fa
st p
lu
g
-in
v
eh
icle
d
a
ta
te
rm
in
a
l
Common faults and solutions of fast plug-in vehicle data terminal
Fault diagnosis
Solutions
No connection with mobile phone
"Click on the switch button, restart the terminal, and then establish a connection between the mobile phone and the terminal. can only be
connected with one mobile phone at a time. If other mobile phones have been connected to the terminal, they need to be restarted and
disconnected.
Unable to boot
"Insert the data terminal into the diagnostic interface completely, click on the boot button, and observe whether the red light is on. If it is
on, it indicates that the connection is successful. If the vehicle battery is confirmed to be electrified, the diagnostic interface is fully
plugged in, and the red light can not be turned on after many attempts to turn on, so it needs to be repaired back to the factory.“
If failing to detect, the system will prompt the "Network
Connection failed".
If the mobile phone does not have the WIFI hotspot established by the terminal device, it will prompt "network connection failure" in the
process of system detection. At the moment, the WIFI connection status or whether the terminal is too far away from the mobile phone
should be detected.
There is a prompt "Please set the ignition switch to ON
gear" on the interface.
If the vehicle ignition switch has not been set to the ON gear, there will be a prompt "Please set the ignition switch to ON gear” during
the diagnosis process.
There is a prompt "Reading fault" shown on the interface.
When the system is tested and if the electronic control system of the vehicle is not within the scope of detection, it will prompt "reading
fault" in the process of system detection. The support model of this system is Jiefang J6 Pilot Version.
Basic information and fault diagnosis
If the vehicle ignition switch has not been set to the ON gear, there will be a prompt "Please set the ignition switch to ON gear” during
the diagnosis process.
Overtime or negative response of electronic control system
during the diagnosis process.
In the process of diagnosis, the electronic control system responds to the overtime or negative noise. It should be prompted that "data
detection is completed", and then the re-detection process can be executed.
Summary of Contents for J6 Jiefang IV Series
