FAW J6 Jiefang IV Series, Operation Manual

Page: 210 / 217

202
Jiefang J6 China IV, China V series instruction
Maintenance
Lubricating oil
Engine oil change
When the vehicle runs (for 10,000-15,000 km),
the oil quantity should be checked. When oil level is
lower than the lower limit of the oil scale, it is
necessary to fill the oil in time so that the oil level
reaches the upper limit of the scale line.
Warning
⊙
Due to the extension of the oil change cycle,
engine must be checked and filled with oil in time
according to the specified mileage to avoid engine
fault due to insufficient oil.
⊙
It is forbidden to add other oil and its
consequences will be borne by the user itself.
Oil change cycle:
- When driving a vehicle for 60,000 km or 12
months, or every 100,000 km or 12 months
(CA6DM2 engine) - Whenever driving 40,000 km
or 12 months (including new vehicles); (CA6DM3
engine)
Caution
⊙
At the same time of changing the oil, the rotary
oil filter and centrifugal oil filter should be
replaced.
⊙
For more than three months in a year, the
interval of oil change will be reduced by half in
gray areas, mountainous areas, cold areas (ambient
temperature is lower than - 20
℃
), or when the
average fuel consumption of the whole vehicle is
higher than 50L/100km. Mileage and usage time
will prevail.
- Park the vehicle on a flat surface and place sliding
resistance block at the wheel.
- Under the state of hot vehicle (the oil temperature
is about 65
℃
), unscrew the oil drain plug on the
lower part of the oil pan (observe the oil heat, and
do not get burned ), and remove the impurities
absorbed by the plug.
- Tighten the oil drain plug after the oil is drained.
Normal
Too high
Too low