Fantic INTEGRA 150 TRAIL, User And Maintenance Handbook

Page: 96 / 101

08
Ed. 1 - 07/2019
EN
G
LI
SH
EN_36
T r o u b l e s h o o t i n g
1. TROUBLESHOOTING
If you encounter problems while riding your bicycle, first check whether the fault is described in the following
tables.
This table is designed to help you identify the correct solution without taking your bicycle to the authorized
vendor.
If the problem is not described in the table, or the proposed solution does not correct the fault, consult the
authorized vendor before using your bicycle again.
Problem Possible cause Possible solution
It is not possible to activate the
display or the power-assisted
pedalling system.
The battery pack has malfunction,
despite being fully charged.
Press the white push-button on
the battery pack to check whether
it is switched on. The battery pack
charge level indicator LEDs should
switch on. If they do not, the bat-
tery pack may be defective.
Battery pack overheated. Wait until the battery pack has
cooled down.
Battery pack not installed correct-
ly.
Remove the battery pack and
attempt to reinsert it into its cou-
pling. Make sure that it is posi-
tioned correctly.
Battery pack discharged. Recharge the battery pack using
the dedicated battery charger.
Electrical contacts on battery
pack and/or connector damaged.
Make sure that all the contacts are
clean. If necessary, clean them us-
ing a soft, dry cloth.
Display not mounted correctly on
its support.
Remove the display from the sup-
port and reposition it. Make sure
that it has been inserted correctly.
Display and/or support contacts
damaged.
Make sure that all the contacts are
clean. If necessary, clean them us-
ing a soft, dry cloth.
Connector not inserted correctly
into the battery pack.
Insert the connector correctly
into the battery pack contact.
The display does not provide any
data, even though the bicycle is in
motion.
The contact on the rear wheel
spokes has not been mounted
correctly or is positioned too far
away from the sensor.
Check the position of the con-
tact on the rear wheel spokes; in
particular, the distance from the
speed sensor must be between 5
mm and 17 mm.
The bicycle lights (if fitted) do not
switch on.
Light power supply cables on
connected correctly.
Check the cables and the electri-
cal plugs and connect them cor-
rectly.
The display indicates an error
code.
A system error is present. Consult the following table.