Fantic INTEGRA 150 TRAIL, User And Maintenance Handbook

Page: 83 / 101

06
Ed. 1 - 07/2019
EN
G
LI
SH
EN_23
U s i n g p o w e r a s s i s t e d p e d a l l i n g
2. REMOVING THE BATTERY
PACK FROM ITS SUPPORT
- Disconnect the connector from the battery
pack (fig. “53“).
- Completely unscrew the battery fixing screw
until you remove it (fig. “54“).
- Raise the battery pack until you release it from
its support and remove it (fig. “55“).
- Place the battery pack on a flat and dry surface.
Do not put the battery pack in
contact with water or other liq-
uids. If this happens, do not use
it and let it be checked by the re-
tailer.
3. CHARGE THE BATTERY PACK
3.a - Activating the battery pack
before use
The battery pack is supplied partially charged.
For this reason, it should be tested before recharg-
ing it.
- Press the button (1) to activate the battery.
· The four LEDs light up in sequence.
- Press the button (1), the LEDs light up for ap-
prox. 4 seconds, indicating the battery pack
charge level.
· If none of the LEDs light up it means that the
battery is completely discharged.
· If at least one LED lights up, the battery is at
least partially charged.
- Press the button (1) for 3 seconds to switch the
battery pack off.
Make sure that the battery pack is fully
charged (all four LEDs lit) before you use you
bicycle.
The battery switches off after 10 seconds.
3.b - Charging the battery pack
(fig. “56“ and “57“)
Always use the battery charger
supplied with the bicycle.
The battery pack may be recharged at any
moment, without affecting the duration,
however:
In order prolong battery life, it
should not be recharged too often,
or left in the discharged state for
more than two months at a time.
- Connect the power cable to the electrical
mains socket.
Make sure that the electrical mains supply
voltage corresponds to the value indicated
on the battery charger data plate.
- Connect the small plug on the power cable to
the socket on the battery charger (fig. “58“).
- Connect the charger connector to the socket
on the battery pack.
- At this point the battery starts to recharge.
- The LEDs on the battery pack light up to in-
dicate the charge level. When all four LEDs are
lit it indicates that the battery pack is fully
charged.
Each LED corresponds to approx. 25% of the
full charge.
- Disconnect the battery charger from its pow-
er supply and the connector from the battery
pack.
- Once the battery pack has been fully charged,
if it remains connected to the battery charger,
and the latter remains connected to its power