XTP II CrossPoint Series • Maintenance and Modifications
86
Replacing the Cable
ATTENTION:
•
The replacement power cable must be no longer than 9.85 feet (3 m) and rated for
200-240 VAC, 16 amps, minimum.
•
La longueur du câble d’alimentation de substitution doit être inférieure ou égale à
3 mètres (9,85 pieds) ; le câble doit être évalué pour 16 ampères à 200/240 Vca
minimum.
•
Ensure that the replacement wiring is in accordance with the electrical code for
the country or region where installed and the wiring color code in force for the
installation site. See the wire and connector specifications in
on page 88.
•
Assurez-vous que le câblage de substitution installé soit conforme aux
réglementations en matière d’électricité du pays ou de la région, et aux codes
couleurs en vigueur dans le lieu d’installation. Consultez les spécifications du câble
et du connecteur sur la
, page 88.
Replace the power cable as follows:
1.
If the matrix switcher is powered, unplug it or remove power from the power outlet or
junction box that powers the matrix switcher.
2.
On the rear of the matrix switcher, remove and retain the 15 screws that secure the
lower panel (the panel with the power connection) in place (see figure 42).
Figure 42.
Power Panel Screw Locations
3.
Pull the fan assembly out of the cabinet (see figure 43,
1
).
2
2
1
1
3
3
3
3
Figure 43.
Remove Fan Assembly, Ground Stud, and Power Distribution Box
4.
Remove and retain the nut securing the ground strap to the chassis ground stud (see
figure 43,
2
). Remove the ground strap.
5.
Remove and retain the two screws that secure the matrix switcher power distribution
box panel in place (
3
). Lift the power box from the matrix switcher.
