XTP II CrossPoint Series • Maintenance and Modifications
87
6.
Remove and retain the screw securing the power distribution box cover in place (see
figure 44). Remove the cover.
Figure 44.
Power Distribution Cover
7.
Disconnect the two external wiring terminal lugs from the terminal block inside the
matrix switcher power distribution box (see figure 45,
1
). Retain the screws.
2
2
1
1
3
3
Figure 45.
Power Distribution Box Interior
8.
Gently pull the ground cable through the rubber grommet into the power distribution
box (
2
).
9.
Unscrew the cable clamp on the power distribution box (
3
). Gently pull the exterior
cable free of the power distribution box.
10.
Gently push the
terminated
cables of the replacement power cord through the cable
clamp and into the power distribution box.
Loosely
reassemble the cable clamp.
11.
Gently push the ground (green and yellow) cable through the rubber grommet in the
side of the power distribution box.
12.
Adjust the length of the cables inside the power distribution box until they reach the
terminal block and ground stud with minimal excess.
13.
Tighten the cable clamp.
