XTP II CrossPoint Series • Installation
17
SDI input connectors
Each SDI connector is accompanied with a local loop out connector.
•
SDI Input connector
— Connect a digital video source to a BNC input connector. The
connector accepts 3G-SDI, HD-SDI, or SDI video and embedded digital audio.
•
SDI Loop Out connector
— Connect a local digital display to the BNC loop out
connector of the associated input signal for a buffered loop-through.
NOTE:
SDI boards ship with 75 ohm terminators on the Loop Out connectors.
Extron recommends leaving these installed when the loop out is not used.
LOOP OUT
INPUT
Figure 9.
SDI Input and SDI Loop Output Connector
Analog video input connectors
Connect a computer video source to the 15-pin HD connector (see
on page 23 for wiring details). It accepts RGB (RGBHV, RGBs, and RGsB),
component, S-video, or composite video signals.
Figure 10.
15-Pin HD Input Connector
Analog audio input connectors
Connect a balanced or unbalanced, stereo analog audio source to the 5-pole captive screw
connector (see
on page 25 for wiring details).
L
R
Figure 11.
Analog audio input connector
By default, the matrix switcher prioritizes embedded digital audio when both digital and
analog audio are present. To send analog audio, use one of the following methods:
•
SIS commands:
•
For input cards, see the
SIS command on page 52.
•
For endpoints, see the
Audio routing selection for endpoints
•
The XTP System Configuration Software (see the
XTP System Configuration Software
Help
file)
