Programmer’s Guide, cont’d
CrossPoint / MAV Matrix Switchers • Programmer’s Guide
4-6
Verbose Mode
Telnet connections to a CrossPoint or MAV Plus switcher can be used to monitor
for changes that occur on the switcher, such as front panel operations and SIS
commands from other Telnet sockets or a serial port. For a Telnet session to receive
change notices from the switcher, the Telnet session must be in verbose mode 1 or 3.
See the
command on page 4-25. In verbose mode 1 or 3, the
Telnet socket reports changes in messages that resemble SIS command responses.
Host-to-Switcher Instructions
The switcher accepts SIS (Simple Instruction Set) commands through either serial
port. SIS commands consist of one or more characters per command field. They do
not require any special characters to begin or end the command character sequence.
Each switcher response to an SIS command ends with a carriage return and a line
feed (CR/LF =
]
), which signals the end of the response character string. A string
is one or more characters.
Switcher-Initiated Messages
When a local event such as a front panel operation occurs, the switcher responds
by sending a message to the host. The switcher-initiated messages are listed below
(underlined).
(c) Copyright 2007, Extron Electronics CP 300 450 MAV IP, Vx.xx, 60-
nnn
-
01 {day,
date, time}
]
— or —
(c) Copyright 2008, Extron Electronics CP Ultra IP, Vx.xx, 60-
nnn
-
01 {day,
date, time}
]
The switcher initiates the copyright message when it is first powered on or when
connection via Internet protocol (IP) is established. Vx.xx is the firmware version
number and 60-
nnn
-
nn
is the switcher part number.
N
{Day, date, time} are reported only if the connection is via the LAN port.
]
Password:
The switcher initiates the password message immediately after the copyright
message when the controlling system is connected using TCP/IP or Telnet and the
switcher is password protected. This message means that the switcher requires an
administrator or user level password before it will perform the commands entered
via this link. The switcher repeats the password message response for every entry
other than a valid password until a valid password is entered.
]
Login Administrator
]
]
Login User
]
The switcher initiates the login message when a correct administrator or user
password has been entered. If the user and administrator passwords are the same,
the switcher defaults to administrator privileges.
Qik
]
The switcher initiates the Qik message when a front panel switching operation has
occurred.
Summary of Contents for CrossPoint 450 Plus 2412 HV
