Extron electronics CrossPoint 450 Plus 2412 HV, User Manual

Page: 73 / 214

3-29
CrossPoint / MAV Matrix Switchers • Operation
Example 6: Setting the RGB delay for an output
In the following example, the RGB delay is increased for output 17. The steps show
the front panel indications that result from your action.
1 . Press and release the Esc button (figure 3-37).
C O N T R O L
PRESET ENTER
ESC VIEW
Press the Esc button to clear all selections.
The button flashes once.
Figure 3-37 — Clear all selections
2
. Press and
hold
the RGBHV button for approximately 2 seconds (figure 3-38).
RGBHV RGBHV
Press and hold the RGBHV
button until it blinks.
2 seconds
Figure 3-38 — Select RGB Delay mode
3 . Press and release the output 17 button (figure 3-39).
1 2 3 4 5 6 7 8 15 16
17 18 19 20 21 22 23 24 31 32
1 2 5 16
17 18 11 32
I
N
P
U
T
S
O
U
T
P
U
T
S
Press and release the
Output 17 button.
The button lights
green.
The input buttons 1 through 10 display the selected
output's RGB delay.
Each lit input button indicates half a second of delay.
In this example, the green input buttons display 3.5
seconds of RGB delay.
3.5 3.0 2.5 2.0 1.5 1.0 0.5
= Unlit button = Lit green button
Figure 3-39 — Select an output
N
The RGB delay is protected when front panel lock mode 2 is selected. You
can view the delay in lock mode 2, but not change it from the front panel. See
“Setting the front panel Locks (Executive modes)” on page 3-52.
If front panel lock mode 2 is selected and you try to perform steps 4 , the actions
are ignored and the Enter, RGBHV, and Audio buttons flash.