Extron electronics CrossPoint 450 Plus 2412 HV, User Manual

Page: 103 / 214

3-59
CrossPoint / MAV Matrix Switchers • Operation
Optimizing the Audio (Audio Models)
Each individual input audio level can be adjusted within a range of -18 dB to
+24 dB, so there are no noticeable volume differences between sources and for the
best headroom and signal-to-noise ratio. Adjust the audio gain and attenuation as
follows:
1 . Connect audio sources to all desired inputs and connect the audio outputs to
output devices such as audio players. See “Audio input and output (audio
models)”, in chapter 2, “Installation”. For best results, wire all of the inputs
and the outputs balanced.
2 . Power on the audio sources, the switcher, and the audio players.
3
. Switch among the inputs (see “Creating a configuration”, in this chapter),
listening to the audio with a critical ear or measuring the output audio level
with test equipment, such as a VU meter.
4 . As necessary, adjust the input audio level of each input (see “Viewing and
adjusting the input audio level (audio models)”, in this chapter) so that the
approximate output level is the same for all selected inputs.
5 . As necessary, adjust the output audio level of each input (see “Viewing and
adjusting the output volume (audio models)”, in this chapter).
Troubleshooting
This section gives recommendations on what to do if you have problems operating
the switcher and it describes an actual image problem that Extron has encountered.
General checks
1 . Ensure that all devices are plugged in and powered on. The switcher is
receiving power if one of the front panel Power Supply LEDs is lit green.
2 . Check to see if one or more outputs are muted.
3 . Ensure an active input is selected for output on the switcher.
4 . Ensure that the proper signal format is supplied.
5 . Check the cabling and make corrections as necessary.
6 . Call the Extron S
3
Sales & Technical Support Hotline if necessary.
Plasma display S-video problem (CrossPoint switchers)
Extron has encountered a problem when a CrossPoint 450 Plus or CrossPoint Ultra
switcher routes S-video that is output by some video conference codecs. Some
codecs change the DC offset on the chrominance (C) so that it is very different from
the level on the luminance (Y). This can cause a plasma display to come up in the
wrong size mode.
With the matrix switcher taken out of the system, the plasma works fine. It looks
like a problem with the matrix switcher, but it is not . The matrix switcher boosts
the bad codec output, which makes the plasma go to the wrong setting.
Solution : Try placing an Extron video DC block adapter, part # 26-495-02 , on the
luminance (Y) input to the switcher from the codec.