Extron electronics CrossPoint 450 Plus 2412 HV, User Manual

Page: 140 / 214

Matrix Software, cont’d
CrossPoint / MAV Matrix Switchers • Matrix Software
5-4
Using the Matrix Switcher Control software
Many items found in the Matrix Switchers Control Program are also accessible
via front panel controls (see chapter 3, ”Operation”) and under SIS control (see
chapter 4, “Programmer’s Guide”). The Matrix S Help Program provides
information on settings and on how to use the control program, itself.
1. To run the Matrix Switchers Control Program, click
Start
>
Programs
>
Extron Electronics
>
Matrix Switchers
>
MATRIX Sw Control Pgm
.
The Comm Port Selection window (figure 5-3) appears.
Figure 5-3 — Comm port selection window
2 . Choose the comm port that is connected to the CrossPoint or MAV switcher’s
rear panel Remote port or to the front panel Config port (matrix sizes up to
1616), IP [LAN] , or Emulate .
If you selected a comm port , check the baud rate
displayed in the comm port selection window. If you
need to change the baud rate, click on the
Baud
button
and double-click on the desired baud rate.
Available rates are 9600, 19200, 38400, and 115200. The
default is 9600.
Click OK and proceed to step 4 .
• If you selected IP [LAN] , click OK and proceed to step 3 .
• If you selected
Emulate
, click
OK
and see “Using Emulation mode” on
page 5-23.
3 . If you selected IP [LAN] in step 2 , the IP Connection window appears
(figure 5-4).
Figure 5-4 — Address and password entry