Extron electronics CrossPoint 450 Plus 2412 HV, User Manual

Page: 97 / 214

3-53
CrossPoint / MAV Matrix Switchers • Operation
Selecting Lock mode 2 or toggling between mode 2 and mode 1
N
If the switcher is in Lock mode 0 or mode 1, this procedure selects mode 2.
If the switcher is in Lock mode 2, this procedure selects mode 1.
Toggle the lock on and off by pressing and holding the RGBHV (CrossPoint Ultra)
or Video (MAV Plus) button and the Audio button for approximately 2 seconds
(figure 3-76).
I / O
VIDEO AUDIO
I / O
VIDEO AUDIO
Press and hold the RGBHV /Video and Audio
buttons simultaneously to turn on Lock mode 2
or to toggle between mode 1 and mode 2.
2 seconds
The RGBHV/ Video
and Audio buttons
blink twice to indicate
the mode change.
Release the buttons.
Figure 3-76 — Toggle front panel lock between mode 2 and mode 1
Performing a system reset from the front panel
The front panel reset is identical to the
E
ZXXX
}
SIS command (see chapter 4,
“Programmer’s Guide”). A system reset performs the following functions:
• Clears all ties and presets
• Clears all video and audio mutes
• Resets all I/O grouping
• Resets all RGB delay to 0 seconds
• Resets all input audio levels to unity gain (0 dB)
• Sets all output volume levels to 100% (0 dB of attenuation)
N The system reset clears most image and audio adjustments. If you want to save
these settings, use the Windows-based Matrix Switchers Control Program and
the
File > Save MATRIX settings as... selection before you perform this reset
(See chapter 5, “Matrix Software”).
Reset the switcher to the factory default settings by pressing and holding the
RGBHV (CrossPoint Ultra) or Video (MAV Plus) button and Audio button while
you apply AC power to the switcher (figure 3-77).
N
System reset does not reset the Internet protocol (IP) settings or replace user-
installed firmware.
I / O
VIDEO AUDIO
Press and hold the RGBHV/Video and
Audio buttons while you apply power to
the switcher.
Release the RGBHV/Video and Audio buttons.
Power
The switcher flashes
the button indicators
and then turns them off.
Continue to hold the RGBHV/Video and
Audio buttons until all input and output
buttons return to either unlit or to
background illumination and the RGBHV
or Video and Audio buttons turn on.
Figure 3-77 — System reset