Extreme Networks e" series, Hardware Installation Manual

Page: 288 / 394

288 Extreme Networks Consolidated "e" and "i" Series Hardware Installation Guide
BlackDiamond 6800 Series I/O Modules
Figure 169: Components and LEDs of the MPLS module
MPLS LED Indicators
The MPLS module has two module-level LED indicators (STATUS and DIAG) (see Figure 169).
•
STATUS LED—Located near the top end of the front panel, near the ejector/injector handle. This
LED indicator is a bi-color LED (displaying in either green or amber) that signals the operating
status of the module.
• DIAG LED—Located beside the STATUS LED. The LED is a bi-color LED (displaying in either green
or amber) that signals whether diagnostics are being run on the module.
NOTE
During the MPLS module boot-up, the Status and Diag LEDs may be incorrectly lit to solid green or
solid amber. The LEDs reflect their true state after approximately 30 seconds when the module has
completed its boot cycle.
For more information about MPLS module LED activity, see “I/O Module LEDs” on page 293.
Service Ports
The MPLS module is equipped with two front-panel service ports: one port is a subminiature DB-9
connector; the other is a micro HD-15 connector (see Figure 169). The ports are reserved for use only by
Extreme Networks technical support personnel for diagnostic purposes.
PoS_002
MPLS_15
Ejector/injector
handle
Service ports
Module status LED
General Purpose Processor (GPP)
Module diagnostics LED
Captive
retaining screw
Network processors
and heat sinks