Extreme Networks e" series, Hardware Installation Manual

Page: 301 / 394

Installing a BlackDiamond 6800 Series Fan Tray
Extreme Networks Consolidated "e" and "i" Series Hardware Installation Guide 301
Figure 174: Removing the BlackDiamond 6808 fan tray
4 Allow the fan blades to stop spinning; then pull the fan tray the rest of the way out of the chassis.
WARNING!
Keep your hands your away from rotating fan blades.
5 Repeat this procedure for additional fan trays, if applicable.
Leave the ESD strap permanently connected to the chassis so that it is always available when you need
to handle ESD-sensitive components.
Installing a BlackDiamond 6800 Series Fan Tray
BlackDiamond 6800 series fan trays are hot-swappable. You do not need to turn off power to a
BlackDiamond 6800 series switch to install a fan tray.
You need the following tools and equipment to install a fan tray:
• ESD-preventive wrist strap
• # 1 Phillips screwdriver
CAUTION
Only trained service personnel should perform service to BlackDiamond equipment. Before installing or
removing any components, or carrying out any maintenance procedures, see Appendix A.
To install a fan tray in the BlackDiamond 6800 series switch:
1 Attach the ESD strap to your wrist and connect the metal end to the ground receptacle on the top
left corner of the switch front panel.
2 Check the connectors for dust and packing materials.
BD_fanx