Extreme Networks e" series, Hardware Installation Manual

Page: 104 / 394

104 Extreme Networks Consolidated "e" and "i" Series Hardware Installation Guide
Summit Switch Models
Figure 51: Summit48si AC power supply
Figure 52: Summit48si DC power supply
If one power supply fails, or if source power to one of the power supplies fails, the second power
supply takes over, ensuring uninterrupted network operation. The switch also sends:
• A message to the syslog telling you which power supply failed
• An SNMP trap to your network management software both when a power supply fails and when a
power supply is hot swapped
Labels
The labels on the bottom of the Summit48si switch display important information about the switch.
Write down the following information before you install the switch:
•
Model number—Shows the model number assigned to this device
• Part number—Shows the part number assigned to this device
• Serial number—Refer to the serial number when you contact Extreme Networks technical support
• MAC address—Shows the unique Ethernet MAC address assigned to this device
Reset Button
Use the reset button to cycle the switch down and bring the switch back up without powering off the
switch. Your saved switch configuration information is not lost; unsaved switch configurations are lost.
Use a non-conductive tool to push the reset button.
48si_psu
Power socket PSU status LEDs
15603
450070-00-XX
100-240 V
3.0 A Max.
50/60 Hz
Serial Number: