Era Replica Automobiles 427 ROADSTER, Assembly And Service Manual

Page: 89 / 165

SECTION E -BODY PREPARATION-
89
ROLL BAR
Insert the 3 roll bar grommets into the rear body cut-outs.
Lubricate the inside of the grommets with silicone spray or
Armor-All

and install the roll bar hoop and support
brace as described on page 71.
RADIATOR AND FANS
All pieces are pre-installed on every kit.
Install the upper shroud on the bottom side of the cowl
inner panel as shown.
E\upradmt
Insert the rubber radiator grommets into the holes in the
radiator support tray and install the tray onto the studs in
the chassis.
Drop the radiator into place from inside the engine
compartment. Fit the rubber grommet to the upper
radiator tab, and install the upper tab from the shroud to
the radiator stud. Secure with large flat washer and cotter
pin. Install washers and cotter pins onto the bottom pins
too.
Install the fan and bracket assembly as shown above.
If you have the optional E.R.A. oil cooler (see page 91),
the support straps from the oil cooler mount are to the
outside of the support straps.