Era Replica Automobiles 427 ROADSTER, Assembly And Service Manual

Page: 100 / 165

SECTION F -SUSPENSION ASSEMBLY-
100
ANTI-SWAY BAR
Studs are already on the chassis. Clean any paint off the
threads before installing the washers and nuts. The
15 /
16
"
front bar is mounted under the front frame extensions, just
behind the radiator.

Bolt the bar in place with the rubber/urethane
bushes and clamps. The link holes slant up toward
the outside.

Install the connecting links between the tab on the
lower control arm and the pads on the ends of the
sway bar.

Tighten the link bolts so that the rubber bush
expands to the diameter of the cupped washer. Do
not over-tighten.
e\fswayb
REAR SUSPENSION, JAGUAR-BASED
XJ COMPONENTS IN E.R.A. SUBFRAME
Thread the trailing arms onto the rod ends (with jam nuts)
already installed on the lower control arms. Thread on
until one or two threads show. Leave the jam nuts loose.
f\rearsusp
Raise the rear suspension assembly into position with a
floor jack, guiding the forward ends of both trailing arms
into the brackets on the sides of the frame. Don’t install
the bolts yet.
f\tralarm